Desk Control Basic Software

The desk cannot drive up if it has not been initialized

If the display shows error code E01, the desk must be initialized.

How to initialize:

1. Press down key and drive to the lowest position. Hold the key until the desk stops completely.
2. Reactivate the down key and hold the key until the desk stops completely. Now the desk can drive up.

AcceptCookies.

AcceptCookies.

Change the height in the display to the correct height of the desk by following the procedure shown in the video or described below.

How to set the height of your desk (DP1C and DPT)

Measure the actual height of your desk – from floor to the upper edge of the tabletop.

1. Press ‘S’ and keep pushing the button until an ‘S’ appears in the display
2. While pushing ‘S’ use the up and down key to change the figure to the actual height

AcceptCookies.

Correct the height in the display to the actual height of the desk by following the procedure shown in the video or in the text below.

How to set the height of your desk

Measure the actual height of your desk – from floor to the upper edge of the tabletop.

Set the height:

1. Press the up and down keys at the same time.
2. A figure appears in the display.
3. Use the up or down key to change the figure to the actual height.

The desk cannot drive up if it has not been initialized.

If display: error code E01, the desk must be initialized.

How to initialize:

1. Press down key and drive to the lowest position. Hold the key until the desk stops completely.
2. Reactivate the down key and hold the key until the desk stops completely.

Now the desk can drive up.

AcceptCookies.

Favorite positions for sitting and/or standing can be stored. Follow the procedure shown in the video or the instructions below.

How to store a position

1. Drive to the height you wish to store
2. Press ‘S’ and then the memory button

Your position has now been stored.

To recall your memory position, press the memory button until you reach the stored position.

AcceptCookies.

The system has set a new end-stop outwards.

To erase this position, the desk must be initialized again. Follow the procedure shown in the video.

AcceptCookies.

The DPT is locked when not in use to avoid unintended drive.

To unlock the DPT follow the procedure shown in the video.

AcceptCookies.

The desk cannot be raised if it has not been initialized.

If the display shows error code 'E01', the desk has not been initialized.

How to initialize your desk:

1. Press the down key until the desk is lowered completely. Hold the key until the desk no longer moves.
2. Reactivate the down key and hold until the desk no longer moves. Now the desk can be raised.

AcceptCookies.