The DP (Desk Panel) is a classic control developed to adjust all kinds of desks ranging from heavy-duty workstations to office desks.
The DP is compact in design and easy to mount under various types of height adjustable desks.
Optionally it can be ordered in a memory version allowing you to store favorite positions.
The desk must be initialized.
Follow the procedure shown in the video.
Check: Is the power line connected to the control box?
Try/Solution: Try to connect a lamp or similar to the power outlet to check that the supply voltage is OK.
Check: Are all plugs mounted correctly on the control box and the leg?
Try/Solution: Check all connections.
Check: Is there any visible damage to the cables, controls, control box or legs?
Try/Solution: Damaged parts must be exchanged. Contact the company that sold you the desk.
The desk cannot drive up if it has not been initialized.
If display: error code E01, the desk must be initialized.
How to initialize:
Now the desk can drive up.
Watch and learn how to easily clean your LINAK desk panel/switch in this short instruction video: How to clean it; which cleaning agents to use; and, last but not least, what you need to pay attention to.
Clean your desk panel with a soft damp cloth. Universal cleaning detergents may be used.
For disinfection of the desk panel, use a 70 percent isopropyl alcohol either as a wipe or add a small amount to a soft cloth.
Warnings
The desk panel is not a sealed unit and there are electronics inside it. If liquids or moisture enter an opening, the PCB may be damaged, and the desk panel ruined.
Therefore:
Alkaline and acidic cleaning agents may, over time, decompose the housing. Hand sanitizer gel may deposit on the desk panel buttons. Over time, the buttons may be stuck, or they may not work properly.
Favorite positions for sitting and/or standing can be stored. Follow the procedure shown in the video or the instructions below.
How to store a position
Your position has now been stored.
To recall your memory position, press the memory button until you reach the stored position.
The system has set a new end-stop outwards.
To erase this position, the desk must be initialized again. Follow the procedure shown in the video.